When selecting the rf connector, any neglect of any link will affect the equipment

The rf connector can be used to transmit radio frequency signals, and its transmission frequency range can reach 18GHz or higher. With the advantages of small size, light weight and ease of use, it is widely used in radar, communications, data transmission and aerospace equipment. With the development of these industries, their requirements for RF coaxial RF connectors are getting higher and higher, and the demand is also increasing. TXGA original direct sales rf connector, sufficient inventory, abundant models, online order, same day delivery, enter [rf connector], immediately place an order.

In the selection process of the rf connector, the neglect of any link will cause the abnormal operation of the entire air conditioning system or fail to achieve the best operating state. Therefore, you need to pay attention to the selection:

1. The selected rf connector must conform to the actual frequency range used.

2. Under normal circumstances, the electrical performance of the straight rf connector is better than that of the bent type, which can be selected according to the actual use.

3. The selected rf connector should have a smaller standing wave ratio.

4. The selected rf connector should have a smaller insertion loss.

5. The selected rf connector should match the impedance of the matched RF connector or cable.

6. The EMC of the threaded rf connector is better than any bayonet or push-pull RF connector.

7. When there is an IM requirement, the material and plating of the rf connector should be considered.

8. When general rf connectors meet the requirements, high-performance RF connectors are not used.