TXGA公告
【Notice】:TXGA Spring Festival holiday is from February15, 2026 to February23, 2026, a total of nine days, and work will resume on February 24, 2026. During the holiday, the website can place orders normally, and delivery will be arranged after the holiday. If you have any questions, you can send an email to the business manager: philomena.li@txga.com.
TXGA连接器厂家 Building Technology Cornerstone
{{ getLanguageDisplayName(lang) }} | CN | CNY
Your current browser version is too low or not supported. Please upgrade or change your browser. Recommended browsers: Chrome, Edge.

Explain the installation process of the cable connector in detail

A cable connector is a connector that can safely terminate two cables. It is mainly suitable for the signal transmission between various digital program-controlled switches, photoelectric transmission equipment and distribution frames in the transmission equipment bureau, and is used to transmit data, audio, video and other communication equipment. TXGA provides cable connectors of various specifications in stock, which are stable and durable, customized by the original factory, and quickly shipped from stock. Enter TXGA [Product Center] to place an order online for convenient purchase.

Due to maintenance, replacement and other reasons, the installation of cable connectors is often not completed in a professional factory. Instead, construction personnel with certain electrician knowledge will complete the installation. In this process, all aspects of the installation need to pay attention to standardized operations to avoid affecting subsequent use. The installation steps of the cable connector include:

1. Disassemble the cable connector according to the written number.

2. After peeling off the skin of one of the ends of the cable, nail it on the nail shaft plate of the cable connector. Leave about 20-30 cm for the cable port and let it tilt downward.

3. In order to avoid the damp air from leaking the cable, it is necessary to use a sealant to seal the cable and the cable connection joint, and then cover the connector cover after the sealant is dried.

4. In order to avoid short circuits, use a copper brush to clean the cable connector, and clean the copper powder in the cable protective sleeve and the cable connector.

5. Correctly connect the internal components of the cable connector.

6. Install the inner card slot on the cable connector and fill it with a small amount of gas to keep the air pressure above 90%. Note that the gas inside must be dry and not contain moisture.

TXGA provides safe, reliable and reasonably priced cable connectors in stock, which can be purchased online. One-click order, quick spot delivery, unlimited order.