The optical fiber quick connector is also called a movable joint, which is used to connect the continuous optical path formed by two optical fibers. Generally speaking, consumers will directly buy finished optical fiber connecting wires, and do not need to assemble connectors and optical cables by themselves. However, you may need to use relevant knowledge in home decoration construction. Txga, the manufacturer of optical fiber quick connector, will introduce it to you.
The optical fiber quick connector mainly includes three parts: main body, shell and tail cap. The assembly steps roughly include three steps.
1. Thread the leather fiber optic cable through the tail cap, and peel off the outer skin of the leather fiber optic cable by about 5 ~ 6 cm with scissors. Then cut off the peeled skin, and pay attention to keep the skin layers on both sides flush. Be careful during peeling to prevent damage to the internal optical fiber line.
2. Place the optical cable in the clamp, keep the outer skin edge flush with the scribed line in the clamp, and then close the clamp cover. Then use Miller pliers to close to the edge of the fixture, cut off the exposed coating to expose the optical fiber, and finally clean the exposed white optical fiber with alcohol.
3. Use the clamp to cut the optical fiber. After cutting, take the optical cable out of the clamp, and then compare it with the figure on the product packaging bag. Align the optical fiber with the hole slot of the main body and insert it until the optical fiber touches the bottom of the main body. At this time, the bending state of the optical fiber can be clearly observed. Press the white crimping cover on the main body to the bottom, then screw the tail cap on the main body and fasten the shell.
Txga has a variety of models of optical fiber quick connectors, which are directly sold by the original factory, with complete models, online procurement and 1pcs from sale. If you need a connector, click to enter the [product center] for purchase.
